6.0L Ford Powerstroke - Front Crankshaft Wear Sleeve Installer

Oil leaks from the front crank seal are a very common problem on the 6.0L Ford Powerstroke Diesel Engine. The Ford special tools required for this job cost over $400 and require 3 hours book time to use following the factory procedure.

Using our wear ring installer and procedure the job can be performed in about an hour. Unlike the factory method, our tool does NOT require removing the radiator, fan, and shroud. The job is nearly impossible to perform without an installation tool due to the delicate nature of the wear sleeve, the location of the harmonic balancer dowel pin, and the fact that the wear sleeve must be driven to a specific depth beyond beyond flush to position in properly.

Attempts to install the sleeve without correct tooling usually result in leaks and comebacks.

Replaces Motorcraft / OTC 303-761 Front Seal and wear ring installer

This listing is for one (1) wear sleeve installer. The pictures shows three (3) installers to illustrate the features.