MAGNUM SHIELDING Handlebar Kit - Viking - 14" - Black Pearl* 48830-414

Clean wiring installations on custom handlebars typically mean compromises—either sacrificing aesthetics or wrestling with cable routing. The MAGNUM SHIELDING Handlebar Kit eliminates that trade-off with a patented internal design that routes your complete wiring harness through the bars without chaffing, pinching, or visibility. Paired with matching braided cables and brake lines, this is a purpose-built solution for builders who refuse to settle for either performance or appearance.

The Viking's engineered internal radius and pre-installed E-Z pull-thru sleeving make installation straightforward—no special tools or fabrication required. Whether you're running hydraulic clutch, throttle-by-wire, or factory switch extensions, these bars accommodate the full electrical ecosystem while maintaining that aggressive, intentional look.

• CNC mandrel bent construction
• 1-1/4" diameter tubing
• 1" center section diameter
• Machined control mounts (not swaged)
• 3-1/2" on-center knurling
• Burr-free internal wiring holes
• Patented peak design—no chaffing
• Pre-loaded E-Z pull-thru sleeving
• Compatible with hydraulic clutch
• Throttle and idle cables included
• Brake lines included
• All hardware and extensions included
• Meets/exceeds OE specifications
• Assembled in U.S.A.
• Cable lengths based on 2" risers
• Requires 1" ID risers (1" center section)
• Black Pearl finish
• 14" rise specification